Swifty
Well-Known Member
I have finally managed to clear a few thing up, so have made a start on preparing to make the Nemett Lynx 15cc SOHC Four Stroke. What material I didn't have on hand, I purchased this morning, all except for the cast iron needed for the cylinder liner. I have ordered the timing pulleys and belt, and will get the bearings shortly.
Apart from mine, Gus is about to start on his, and Doubletop from NZ has one on the go already.
I better go and clean my workbench up ready to make a start, the first piece to be machined will be the crankcase, fortunately I already had a machined block that was the correct size for the height, with minimum to be machined off the other sides. This was fortunate, as I don't have a bandsaw and I would have had to order a block cut to size. All the other material, I just call into my supplier and buy offcuts.
I will try and take a lot of photos and post often on the progress, so stay tuned.
Paul.
Apart from mine, Gus is about to start on his, and Doubletop from NZ has one on the go already.
I better go and clean my workbench up ready to make a start, the first piece to be machined will be the crankcase, fortunately I already had a machined block that was the correct size for the height, with minimum to be machined off the other sides. This was fortunate, as I don't have a bandsaw and I would have had to order a block cut to size. All the other material, I just call into my supplier and buy offcuts.
I will try and take a lot of photos and post often on the progress, so stay tuned.
Paul.