- Joined
- Dec 31, 2010
- Messages
- 797
- Reaction score
- 202
As suggested, practice on a piece of scrap. There is a bit of a learning curve. You'll be in a world of hurt if you screw up the flywheel. It's a royal pain to get the paint off after.
Have you checked the voltage at the supply receptacle versus the oven's recommended operating voltage? Low voltage could result in oven not reaching temp. Just a thought. RickI spoke to Eastwood again today regarding the new oven they are sending me. Found out that the ovens are back ordered and won't be in until the end of November.---POOP!! This doesn't really hurt me too much. I guess I will go back to working on my model engines. I will keep you posted about how this turns out.---Brian
Enter your email address to join: