Luc 's builds of Rupnow Engine".

[Brian Rupnow]

Luc---It a beautiful thing!!! Where are our other posters?? I hope it hasn't come down to just you and I.

 

[Canman]

im still with you guys. ive just been working really busy with work not had much time for myself with sorting out stuff for my wedding aswell. check out my thread ive got materials and some parts marked out just gotta finish my new tool post for my lathe and im away.

 

[Brian Rupnow]

Luc--Do you have access to a set of gear cutters to make your timing gears?

 

[canadianhorsepower]

Luc--Do you have access to a set of gear cutters to make your timing gears?

yes I have the complete set, might do the bevel also

 

[Brian Rupnow]

That's awesome. I wouldn't know where to begin to cut a bevel gear, but I know people do it.

 

[kvom]

That's awesome. I wouldn't know where to begin to cut a bevel gear, but I know people do it.

I've read to cut each tooth three times, once in the center and then once on each side so that the outside is wider then the center.

 

[Swifty]

If members look under the "article" heading in the banner at the top of the page, I have written an article on cutting bevel gears.

Paul.

 

[canadianhorsepower]

That's awesome. I wouldn't know where to begin to cut a bevel gear, but I know people do it.

Brian, if you look at the picture of the first set their is a book on one of the pictures on how to make gears, it's from Busy Bee 12.00 or so and well edited

 

[canadianhorsepower]

Hi guys I decide to rename my post to
Canadianhorsepower's build of Rupnow engine
keep following
cheersThm: