Penguingeoff
Well-Known Member
- Joined
- May 19, 2009
- Messages
- 52
- Reaction score
- 2
Whenever I build something, I usually try to see how far I can go. Take the Liney Thimble. How hard would it be to make a 6 cylinder radial out of it. (Those who remember, I made a 3, 5 and 9 cylinder radials out of K&S brass tubing.)( Posted somwhere here)
This is original
This is the 6 cylinder.
Made very similar to the Thimble, except for the crankcase, master/slave rod.Although, I followed my usual procedures when attempting something like this. I made it up as I went. I will have to make a mount for it as yet, however IT WORKS fine as the vid shows.
Cheers from Tasmania - Geoff
This is the 6 cylinder.
Made very similar to the Thimble, except for the crankcase, master/slave rod.Although, I followed my usual procedures when attempting something like this. I made it up as I went. I will have to make a mount for it as yet, however IT WORKS fine as the vid shows.
Cheers from Tasmania - Geoff
