6 Cylinder Inline (To Be)

[Draw-Tech]

Here is a preview of my design for a inline 6 Cylinder, I have been working on the design for over a month, the file is so large it runs slow even thou I have 8 Gigs of Ram. The bore is 1.125", Stroke is 1.25". The carb is a bowl type so the fuel tank is higher than the carb. I have designed a in sump oil pump that feeds up into the rockers, and drains down through the lifter compartment, and flows over the Cam. The lower end depends on splash, with grooves in the mains & holes in the rods. Full designed radiator, and water pump, ported through out the Block and Head. Ignition system uses a 12 volt coil with points (My own build), and a Distributor with 6 lobe Cam. Idon't know when I can start to build need to finish my 4 Cylinder Opposed build. I hope to have the plans available after I build one, for around $25.00 on CD should be 50 to 100 drawings.

View attachment 6_Cylinder_Inline_Engine.pdf

View attachment Carburator.pdf

 

[prophub]

Very cool!

Looking forward to watching it come together.

Shawn

 

[vcutajar]

Yes, this would be very interesting.

Vince