The bushing ought to do the trick !!
Scott
Scott
Ford's Quadricycle Engine
- Thread starter Rdean33422
- Start date
Help Support Home Model Engine Machinist Forum:
Too cold in the shop for me to stay long but I did get a couple of things done.
I installed the power box and hooked up the electrical connections.
They even worked!
Started on the fuel tank.
Thanks for looking
Ray
I installed the power box and hooked up the electrical connections.
They even worked!
Started on the fuel tank.
Thanks for looking
Ray
These are the parts to the gas tank.
I cut the round ends oversize from a piece of plexiglass then use this turning method.
The plexiglass is pressed between two steel slugs one in the chuck and one in the live center. I leave the protective film on the part until after it is cut to size using a fine feed. The pieces are assembled using 5 min clear epoxy.
Thanks for looking
Ray
I cut the round ends oversize from a piece of plexiglass then use this turning method.
The plexiglass is pressed between two steel slugs one in the chuck and one in the live center. I leave the protective film on the part until after it is cut to size using a fine feed. The pieces are assembled using 5 min clear epoxy.
Thanks for looking
Ray
Last edited:
