Webster Build Questions and Progress

[minh-thanh]

I might be a little dense in this regard. But, is the arrow pointing toward the chuck on the lathe?

I was a little busy this morning.
So, Hello again
Don't worry about questions, all questions are welcome !!

 

[Danuzzo]

Finished the cylinder, at least I think so. Used 400 grit and 600 grit silicon carbide. Feels and looks very smooth. No mirror shine, but from what I understand, not required for the Webster (please correct me if wrong). Thanks to all that assisted me with my first lapping job. Could be done better; but, I wanted to leave well enough alone. I did finish the bore at .873". Here are some photos.

Now I am moving on to the crankshaft and flywheel. I plan on asking further questions on this part of the build in a separate thread.

Edit: I looked at the magnification of the attached pictures, and they don't look so good. If anyone thinks I should continue lapping, please feel free to say so.