Radial 5

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

sbdtasos

Well-Known Member
Project of the Month Winner
HMEM Supporting Member
Joined
Oct 29, 2011
Messages
161
Reaction score
363
Hi again :)
it was time to start a radial engine for my collection So i ask Terry's help for this
Terry share with me everything is needed to start my radial engine
IMG_20210112_201251.jpg
IMG_20210112_201302.jpg
IMG_20210112_201306.jpg
 
Very cool. I couldn't figure out what was going on with the yellow tinged bottom in the first picture of the inside piston machining. Then I realized it was full of coolant. What did you use to machine the inside of the piston, a small ball end cutter?
 
Very cool. I couldn't figure out what was going on with the yellow tinged bottom in the first picture of the inside piston machining. Then I realized it was full of coolant. What did you use to machine the inside of the piston, a small ball end cutter?

the inside of the pistons machined with 4mm ball mill 2 flute
 
😳 o looking very nice I’m new to this one will we following with interest 👍
 

Latest posts

Back
Top