Need help finding an old post

[bearcar1]

Well I must be finally 'over the moon', I guess that is better than being under one. :big: Anyway, I remember reading a construction thread on this tramming tool and for the life of me I cannot find it anywhere. I have tried the search for a couple of hours and no-dice. Can someone please direct me to the file outlining the steps for this tool's construction? Thank you.

BC1
Jim

 

[bearcar1]

Never mind, the moon finally landed on me. I found the article in question on another forum. Sorry to have wasted your time.

BC1
Jim

 

[d-m]

BC could you link that to this post I would like to look at it .
Thanks Dave

 

[zeeprogrammer]

Hope no one minds my jumping in here...

I got this from Foozer. Does it help?

http://madmodder.net/index.php?topic=822.0

 

[bearcar1]

D-M, Zee is too quick for me. That is exactly the write up I was looking for, thanks Zee'. I'm certain there are other methods of producing that indicator holder, but it appeared the be relatively straight forward. I have to laugh, I spent quite some time on here doing a search of tram, tramming, indicator holder, etc. and just a few short minutes after my original post I thought "hey stupid, what if it isn't on this forum.......DOH" Anyway, it has been found and shared.


BC1
Jim

 

[d-m]

And as allway well written by John, Thanks Zee & BC I have wanted to build this for some time but new there was more to it than just drilling some mounting holes and hoping for the best. i was Farly close gathering up the necessary scrap to make this I have the 2 indicators the alum bar and some 3/4 round off I go to the shop but unfortunately have a side job to deal with.
Thanks again
Dave