Mirror Finish Fly Cutter
- Thread starter celsoari
- Start date
Help Support Home Model Engine Machinist Forum:
BaronJ
Grumpy Old Git.
Hi Guys,
I posted pictures of mine ten years ago !
I posted pictures of mine ten years ago !
Nice built.
I was able to turn on english captions, and so that worked out.
Makes an impressive finish.
I need to build one of these.
.
I was able to turn on english captions, and so that worked out.
Makes an impressive finish.
I need to build one of these.
.
BaronJ
Grumpy Old Git.
Hi GreenTwin,
Here are pictures of mine. I have drawings kicking about somewhere as well !
No milling ! Just thee holes. One for a 20 mm shaft, one for a 6 mm square tool bit and a M6 threaded hole for a grub screw.
The disc is made from the off cut of a 100 mm steel bar, 20 mm thick with a pressed in steel shaft.
The surface finish is what ever you want depending upon surface speed and material being machined.
Here are pictures of mine. I have drawings kicking about somewhere as well !
No milling ! Just thee holes. One for a 20 mm shaft, one for a 6 mm square tool bit and a M6 threaded hole for a grub screw.
The disc is made from the off cut of a 100 mm steel bar, 20 mm thick with a pressed in steel shaft.
The surface finish is what ever you want depending upon surface speed and material being machined.
I might make one too....I guess it would cut ok, being a full circumference tool head, balanced, and wouldn't bounce on impact of intermittent cutting....
