Identify taper turning attachment

[clemlou]

Hi,
I would like to identify this taper turning attachment. The overall dimensions are approximately 15.5" by 10.5". There is a t-slot for a toolpost at the front end closest to the operator. There are two holes, one on each side, that would appear to allow bolting to the cross slide. There are no identifying letter, numbers, or logos on it. It is new.

Thanks in advance for any help,
Lionel Charron

 

[Peter.]

Is the tee slot for a toolpost or could it possibly be for a follower rest?

 

[clemlou]

Peter,
I'm not sure that it is for a toolpost. I assumed it was without knowing there were other possibilities.

Lionel