Huff & Puff

[doc1955]

Well I picked my next engine build.

 

[doc1955]

Well here is what I have so far today
I have the cylinder done and the cylinder head.
Also got a goo start on the base.

 

[doc1955]

Hmm well ok then.

 

[michael-au]

Looks good Doc

 

[billco]

Well here is what I have so far today
I have the cylinder done and the cylinder head.
Also got a goo start on the base.

I like this little engine I think it would make a great gift, no air hose ,no steam boiler . Where did you get the plans? Is it from castings or just bar Stock ? I will be following this build for sure

 

[mayhugh1]

It'll make a nice tie clip...
Terry

 

[doc1955]

Ok here is where I'm at now.

 

[vederstein]

Itty Bitty Fiddly bits - Nope! Not me!

Been there. It was not entirely enjoyable.

But hey, whatever floats your boat.

 

[doc1955]

I don't mind itty bitty once in a while but I wouldn't want all of them to be small. With itty bitty the clean up is a chore almost a whole tablespoon of swarf LOL

 

[doc1955]

Got the last parts made. I am going to powder coat and may make a video of that.

 

[michael-au]

Where is the plan for this Doc

 

[werowance]

hey Doc, that looks nice. curious what size screws you are using. so tiny

 

[doc1955]

The screws are 0_80 and 1_72 mostly 0_80

 

[doc1955]

 

[Longboy]

Don't put that one in your pocket.....you'll loose it in the laundry.

 

[retailer]

Excellent work - getting them to run with breath power which is around 3 psi is not that easy - fit and finish has to be spot on.