Well, got it all back together.
Holy Cr@p! When I trammed it back up, left side was touching the table the right side was about 1/16 in the air!
This was over a 10 inch span.
Anyway, got it back to with .0003. Didn't feel like chasing that one all night so I left it there. Set up the square on the table and ran the DTI along the blade. Since it's a tenths indicator it was pretty bouncy and hard to get a real accurate reading but it looks like it's out about .006 over 4 inches. Still pretty bad, but better than .050 over 8 that it was.
Holy Cr@p! When I trammed it back up, left side was touching the table the right side was about 1/16 in the air!
This was over a 10 inch span.
Anyway, got it back to with .0003. Didn't feel like chasing that one all night so I left it there. Set up the square on the table and ran the DTI along the blade. Since it's a tenths indicator it was pretty bouncy and hard to get a real accurate reading but it looks like it's out about .006 over 4 inches. Still pretty bad, but better than .050 over 8 that it was.
