Bastelmike
Well-Known Member
- Joined
- Sep 12, 2012
- Messages
- 70
- Reaction score
- 6
Okay, Nick
As I've written before, I have abandoned that idea already. The reason is that I can't get the boring bar out of the bores to measure the diameter. The Y travel isn't long enough and I can't remove the boring bar out of the mill because MT5 is larger than these holes.
So I will do it prob similar to Your proposal. Just one question, I'll do it in German, excuse me.
Würdest Du die zweite der fluchtenden Bohrung nach Kantentaster anfahren, oder besser mit einem Puppitast die erste Bohrung abfahren und danach dn Tisch positionieren?
Also I'm not sure whether I will use the horiz. mill because it lacks a DRO. We'll see
Mike
As I've written before, I have abandoned that idea already. The reason is that I can't get the boring bar out of the bores to measure the diameter. The Y travel isn't long enough and I can't remove the boring bar out of the mill because MT5 is larger than these holes.
So I will do it prob similar to Your proposal. Just one question, I'll do it in German, excuse me.
Würdest Du die zweite der fluchtenden Bohrung nach Kantentaster anfahren, oder besser mit einem Puppitast die erste Bohrung abfahren und danach dn Tisch positionieren?
Also I'm not sure whether I will use the horiz. mill because it lacks a DRO. We'll see
Mike