Search results

HI and welcome from krv3000

HI and welcome from krv3000

HI and welcome from krv3000

well thats brill

HI all has any one got a 5" 4 jaw chuck that will fit a emco compact 8 lathe as cheep as possible regards bob

well dun

HI work is brill

HI well with the center locked off their is no run out with the center rotating their is sum but when under lode their is non I did not say in the post the type of bearings yous ed their where three thrust Bearings I got thes from nsk bearings ther factory is not that far a way from me I just...

i then made up a grease nipple and gave it a good greasing

i then got sum silver steel and ruff out Wat will become the center point it self turned it dawn to 13mm then turned it dawn to 9mm by 15 long then turned it dawn to 5.5mm by 10mm long then i made up a Bering blank to support the center while i drilled threw the 2mm hole in to the 5.5mm step...

i then ruffed out the peace of stainless steel then silver soldered it to the MT2 shaft refitted back on the lathe and checked all was still on center i then center drilled then drilled m6 to a depth off 21mm then i Bord out to 17mm this is the OD of the bearings to a depth of 18mm i then...

HI all not posted for a wile i needed a better running center as the one that i got off the net is to big see pic i have seen Meany plan's of home made running centers so i decided to have a go and mack my own i needed a MT2 i piked up a broken drill from the boot sale for 20p this will be the...

pics

Hi yep plastic resin kits its a clear resin which you ad proper coloring to then mix in the hardener then pore in to your Paten leev to dry over night sum where worm hay presto but the Paten must be absolutely spotless no oil or the resin will lift keep the Base of the mode as ruff as possible...

HI their are screws to a just the top slide to stop this strip the top slide dawn give it a good clean and re oil then a just the screws to stop the side to side movement

HI rdg have them dise in stock

HI well old Bering's mack good parallels cut them in have and you get 4 two from the outer ring and two from the center ring

well dun

hi all well i went posh i made my saw see pic 1

HI nice work