Search results

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. G

    Help with reading dimensioning

    Thanks for all the help. I'm a rookie but a fast learner. My engineering degree is in electrical but I've mainly done software development for 25 years. I've always wanted to learn how to machine metal parts. The part I needed to drill the spot face is where the tube is entering the cylinder...
  2. G

    Help with reading dimensioning

    I'm working on my first small engine project and just learning to use my new metal lathe. I got the plans for the Launch Engine from littlemachineshop.com as a starter project for learning. On the cylinder head a fitting screws in at the top side. The drawing says ".22 DIA. Spot Face to Full...
  3. G

    Hi from Tucson

    Thanks...I did a search here for oscillating cylinder engine and landed on a thread mentioning a project from littlemachineshop.com so I went there and ordered a couple sets of plans with materials that should be good for me starting out. One of my early tasks is that I ordered a four bolt tool...
  4. G

    Hi from Tucson

    Hello...I stumbled on this site while shopping for a metal lathe. I was amazed at the stuff you all are building. I've mainly been making pens on a wood lathe and a few bowls and pepper grinders. Now I've ordered a Jet 9x20 and found this site while searching about lathes. I'd like to find a...
Back
Top