Gordon

At this point I have determined that it is leaking around the spark plug. There is no good way to remove the liner to reseal it so I am...

No cooling. I have not been able to get this thing to run long enough for it to get hot. :) I think that I am leaking around the...

What should be used to seal a cylinder liner in a cylinder? I have a liner made from DOM tubing in a steel cylinder. It has holes in the...

Has anyone here built an Atkinson Differential using the design by Brooks Pendergrast? I built one using the Gingery plans a few years...

I don't know about the cheap hearing aids but for the more expensive ones there are different domes available which permit or block...

Actually insurance is a big part of the problem. Folks don't care what the doctor/dentist/audiologist charges because it is cover by...

As someone with severe to profound hearing loss I can tell you that wearing the hearing aids all day every day once they are adjusted to...

OK As I understand it what I need is Futaba connectors, not JR connectors to fit my existing connectors. Mostly what I have are S/S...

I have also done that. I finally got a set of cheap <$35 index plates for my rotary table so that is what I use now. I have even made...

As you said, everybody has their own standard. I am mainly using the connectors on Hall sensors and the battery pack to run the ignition...

OK I am sure that the the error is either my poor typing skills or my equally poor spelling skills. It looks like the problem with...

I am confused about the connectors used for the CDI ignition modules for the Hall sensor and the battery connector. They say that they...

Actually making your own cutters is not that difficult. I have used the cutters made according to...

I do find it interesting that folks are upset about the "Break Room" category going off topic. I have never even noticed that there was...

I used a slide rule frequently in one of my first jobs. It was a sales office where we purchase the parts and subcontracted fabrication...