dsage

Brian, my goodness. How many I.C. engines have you built, at least a dozen or so? All the elements are the same, valve seal...

Hold your finger over a spark plug hole. Not looking for an absolute value. Just that the valve timing is such that you have compression...

Do you feel suction if you put your finger over the carb air inlet? With your finger over the inlet will it suck gas? (assuming clear...

Well. There ya go. And loctite is the answer?? (NOT) The plugs don't really need to be tight. Use an O-ring under them to get you going...

Don't you have the usual copper washer/gasket/ring on your spark plugs?

I think the flexible filaments would work. But the shape might be an issue. Worth a try though.

At the Indiana show Roy asked me if I could deliver the package to you. I'm not as close to you as he thought. Apparently (he said) that...

That's fine. Folks can use whatever one they want and ask if they don't get it.

Good. It's always harder to explain it (write it out) than it is to do it. Also you'll notice I went back and corrected my error(s) for...

we are in 100% agreement :-) !!!

Sorry. I made a mistake in my dissertation in post 268 I have gone back to (hopefully) correct / clarify it. So Yes. Time the engine...

I've seen it on the forums, both this one and other groups. Guys are saying they are worried about shows getting smaller and are worried...

Unless you have really excessive dwell (points closed - Hall active) then under normal operating conditions - even at cranking speeds -...

Hmm. I was there Friday to set up and I went around to all the cars. You just had to make your way through the exhibitor tables to the...

I guess it depends on which outlet and when I guess. They had basic black and white when I was there a year ago. Stuff always comes and...