machinerguy
Member
- Joined
- Feb 20, 2012
- Messages
- 18
- Reaction score
- 0
Don't be bored, this is an introduction.
The PMR boiler was a pleasure to build. Good fit and well instructed like an old Monogram model kit. It needs a base to hide a Coleman converision, and a tree of PMR's 3/16 fittings to run the 10V. I'm accepting opinions on condensers, tanks & feedwater pumps.
The Mich-Cal#2 is mostly on standby. Trucks are about 95% built and need fitted. Most boiler parts are cut. Now I need to fit crosshead bearings and usually find easier/more important things to do.
Lots of busy.
The field of metalwork is vast. I've been in it a long time and still learn every day. I know a lot about a few things and a little bit about a lot of things. I came here to learn and will gladly help whoever I can.
Thanks again!
The PMR boiler was a pleasure to build. Good fit and well instructed like an old Monogram model kit. It needs a base to hide a Coleman converision, and a tree of PMR's 3/16 fittings to run the 10V. I'm accepting opinions on condensers, tanks & feedwater pumps.
The Mich-Cal#2 is mostly on standby. Trucks are about 95% built and need fitted. Most boiler parts are cut. Now I need to fit crosshead bearings and usually find easier/more important things to do.
Lots of busy.
The field of metalwork is vast. I've been in it a long time and still learn every day. I know a lot about a few things and a little bit about a lot of things. I came here to learn and will gladly help whoever I can.
Thanks again!
