Stirling helicopter

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

gg89220

Well-Known Member
Project of the Month Winner
Joined
Nov 17, 2012
Messages
333
Reaction score
952
hello
Start of the construction
IMG_4749 [800x600].JPG
IMG_4750 [800x600].JPG
IMG_4751 [800x600].JPG
 
Looking good, I just finished 2. Hope your bevel gears are better that the ones I purchased. They were (looked like to me) 3d printed and not well at all. They were not concentric with the hole and lopsided.
 
Hello
quick questions ... on the flywheel rep 12 there are 5 holes Ø 11 and 1 hole Ø 8, why? do you have to orient the flywheel in relation to the piston?
can the engine run without the blades? or they are useful to have inertia?
thank you
 

Attachments

  • HelicopterPlans.jpg
    HelicopterPlans.jpg
    94.7 KB
Excellent question I know mine tremble a bit when running but I never spent any time changing the position to see if it would help. Maybe I should spend some time and see. So in short I don't have an answer for you. I may have just gotten lucky and have the positioned close to oppisit the piston. I'll need to check on that next trip to the shop and see. I would venture to say yes the smaller hole is there to take some of the shake out, I never even gave it any thought but I will now lol.
 
It does help a little
When I first ran my version I ran it without the tail rotor assy or the main blades
One thing I found made a difference to the engines speed was to fit a ptfe washer between the flywheel and the lower main bearing.
 
No blade are not necessary can be run with out. I have mine set up with the small hole in flywheel towards the tail with the power piston at top of stroke and the vibrations are minimal funny how I have both the same as it happened just by chance. lol
 
hello
engine part, piston, cylinder,
IMG_4786 [800x600].JPG
IMG_4787 [800x600].JPG
IMG_4788 [800x600].JPG
 
Hello,

this is my version of the helicopter, the only problem I observed were the bushings of the displacement cylinder, they broke while drilling until I got myself a 2.95 mm carbide drill.

Thorsten
 

Attachments

  • IMG_0395_x264_001.mp4
    5.5 MB
Very nice, really original, is there a project to be able to replicate it?
Thank you
 
Back
Top