some new tools

[chuck foster]

the gib strip is one i made and it is the full length of the top slide (12") and it is made of brass.

chuck

 

[chuck foster]

well the turn table that i have been making is almost done!!!
i tried to copy chuck fellows turn table he made and showed a video of here on hmem, i think it will be a great addition to my little work shop!

here is a few pictures of were i am at as of tonight, just have to put some adjuster screws in on the stops and it should be done.

i hope to have this finished by tomorrow night and then i have to make a small set of hold down clamps for then i can try it out and see how well it works!!

chuck

 

[chuck foster]

just finished making this little tool for setting my lathe tool bits on center.
it was an easy thing it make and i thought about putting up pictures of the whole prosses but it is very easy to figure out from the one picture.

chuck

 

[ShopShoe]

Chuck, Thank you.

These are all great and you have obviously spent a lot of time thinking them through.

--ShopShoe