Project of the Month - September 2018

[Shelton]

Congratulations! gg89220​

You are the builder of the​

Steam Crane​

Here is the Build thread.

A photo of it will be featured as the cover photo on the HMEM Facebook page.

 

[minh-thanh]

gg89220
Congratulations !

 

[ShopShoe]

Congratulations gg89220.

--ShopShoe

 

[Cogsy]

Beautiful build and a deserving winner. Congrats!

 

[deeferdog]

Lovely piece of engineering, well deserved as a winner. Cheers, Peter.

 

[Johno1958]

Congratulations . Very nice.
Cheers
John

 

[Rocket]

Beautiful work! I would like to know if there is something that I can apply on copper to prevent flux and solder from running all over the project. Something like a painter's masking tape in liquid form perhaps? I've heard that wide pencil lines stop the flux from travelling to unwanted areas but I haven't tried it yet. Any ideas out there? Thanks folks.

 

[toolznthings]

Very nice and congratulations !

 

[olympic]

Fine work! I've been thinking about making a crane, but haven't yet begun to translate my thoughts into action. You're miles ahead of me, and the quality of your work shows that you always will be.

 

[Herbiev]

Well deserved. A work of art.

 

[goldstar31]

Beautiful work! I would like to know if there is something that I can apply on copper to prevent flux and solder from running all over the project. Something like a painter's masking tape in liquid form perhaps? I've heard that wide pencil lines stop the flux from travelling to unwanted areas but I haven't tried it yet. Any ideas out there? Thanks folks.

A 2B or softer pencil or White Out. Is the latter still available for two finger typists?

Regards

N

 

[rlukens]

Nice job. Congratulations

 

[Gedeon Spilett]

Nice job Gégé89, congrats, Bravo !

 

[gunner312]

A 2B or softer pencil or White Out. Is the latter still available for two finger typists?

Regards

N

Also, a General's Silver pencil works well when applied where the silver solder is not wanted.

 

[natalefr]

Congratulations Gégé

 

[Michel_Mike_Chaput]

Very nice !

 

[lynxs]

Very nice!