Power Feed.
- Thread starter gus
- Start date
Help Support Home Model Engine Machinist Forum:
Niels Abildgaard
Well-Known Member
- Joined
- Jun 13, 2010
- Messages
- 564
- Reaction score
- 107
I have problems enough using my mobile phone,so an electronic leadscrew will bring no joy.
It is not a big job done often to manage the geartrain for screwcutting .
The possibility to change feed rate and revs during cut will be loading my simultaneous capacity and be nice to listen to with fresh batteries in hearing aid.
- Joined
- May 27, 2010
- Messages
- 2,999
- Reaction score
- 1,171
Labelling the Forward/Reverse Switch and Speed Pot. was quite fun. Dymo Label not preferred as they get smudged. Went to letter stamping on aluminium strips.After 4 days I managed to get some respectable labels stuck on. Nailing on not good looking and hard to align. Contact Glue is messy. Went over to double sided tape. Foto 1 not happy. Foto 2 OK for now.
DIY cutting aluminium blanks was another exercise done umptheen times to get best looking blank. A permanent stop/guide had to be made for the DIY Makita BandSaw to get very parallel strips to cut blanks. Blanks had to be hand finished so that stamped labels looked good.:wall:
Will take a lot of practice to make good labels.
DIY cutting aluminium blanks was another exercise done umptheen times to get best looking blank. A permanent stop/guide had to be made for the DIY Makita BandSaw to get very parallel strips to cut blanks. Blanks had to be hand finished so that stamped labels looked good.:wall:
Will take a lot of practice to make good labels.
