ozzie46s H9

[ozzie46]

Started Feb2022, 1st startup 9/16/23. 1st good runs 9/18/23.
All manual machining although I do have DROs on my bench mill.
Wish to thank Steve Hucks for an assist on crank and Terry Mayhugh for some info.

Ron Osborn,aka ozzie46

 

[stevehuckss396]

Nice job! Hope mine runs half that good.

 

[ozzie46]

Nice job! Hope mine runs half that good.

Thanks Steve , it keeps running better each time I run it.
You should see my "wall of shame" of "practice parts". It's quite extensive
Ron

 

[almega]

That looks great and sounds great! Nice work. I understand the "wall of shame"; I have an "OOPS!" box for every project I do, which provide lessons for the future.
I am just curious, so how large of a model airplane would that be able to be mounted in and made flyable as a remote control plane?

 

[minh-thanh]

Started Feb2022, 1st startup 9/16/23. 1st good runs 9/18/23.
All manual machining although I do have DROs on my bench mill.
Wish to thank Steve Hucks for an assist on crank and Terry Mayhugh for some info.

Ron Osborn,aka ozzie46

A masterpiece.
Congratulations !

 

[ozzie46]

Thank you. The plans state on them that the engine is not intended to mounted on a model airplane.
That being said it probably could be, but I would never put something in the air that I spent almost 2 years building. I flew RC so I know what happens to things that go up, they must come down and not always in one piece. As to size , I have no idea but the engine itself weighs in the 11 lbs. range so it would have to be rather large.

Ron

A masterpiece.
Congratulations !

Thanks Minh-thanh

 

[bobden72]

Started Feb2022, 1st startup 9/16/23. 1st good runs 9/18/23.
All manual machining although I do have DROs on my bench mill.
Wish to thank Steve Hucks for an assist on crank and Terry Mayhugh for some info.

Ron Osborn,aka ozzie46

Great job and sounds great.

 

[ozzie46]

Great job and sounds great.

Thanks
Ron