narrowgauger
Active Member
- Joined
- Oct 26, 2010
- Messages
- 34
- Reaction score
- 4
Hi Guys
I am looking for a member living in the vicinity of Myrtleford Victoria who might be able to assist me with the installation of a new control board & wiring of my small lathe.
whilst I am a reasonable model buider the electrical problems on the lathe have me completely puzzled.
basic problem is a persistent mains voltage blowing of the supply fuse, to the extent that the terminals actually melt. have the new PC board available, but have been unable to find the primary fault.
many thanks in anticipation
Bernard
I am looking for a member living in the vicinity of Myrtleford Victoria who might be able to assist me with the installation of a new control board & wiring of my small lathe.
whilst I am a reasonable model buider the electrical problems on the lathe have me completely puzzled.
basic problem is a persistent mains voltage blowing of the supply fuse, to the extent that the terminals actually melt. have the new PC board available, but have been unable to find the primary fault.
many thanks in anticipation
Bernard
