john137
Member
- Joined
- Jun 26, 2010
- Messages
- 5
- Reaction score
- 0
It has been a while sence i was last on! My name is Eric, I'm a gunsmith by trade ! Hobbys are steam, r/c and watch repair. I seek Ideas for a steam porta power unit! That can run a watchlathe, or clisby lathe. The project will be built on a taig lathe with mill add on! I hope for help in picking a steam engine plans that can produce an 1/8 to a 1/3 horse in power! With out scaling up or down in plans! If this is possible please let me know!
