Started to make a few parts for the Demon
Made 2 Rockercovers
Machined the top first and flipped over to finish off
Made 2 Rockercovers
Machined the top first and flipped over to finish off
Demon V8
- Thread starter michael-au
- Start date
Help Support Home Model Engine Machinist Forum:
Main Bearing caps
Good start!
Timing cover made
Distributor cap made from perspex
Last edited:
Bellhousing adapter
Last edited:
Throttle Lever
Timing pointer
Thermostat housing and nipple that will be soldered on to the housing
Carby bowls partly finished
Front pully partly finished , just need to drill holes. for the fan
Rockercover in this pic is unfinished, was thinking of making one with a breather cap on it, not sure if I use it or not yet
The brass piece is the start of the thermostat
Rockercover in this pic is unfinished, was thinking of making one with a breather cap on it, not sure if I use it or not yet
The brass piece is the start of the thermostat
Making the water pump
Two fixtures were made to hold each half while machining
Machining the first side
Parts are then screwed into the fixture and the second side is machined
Two fixtures were made to hold each half while machining
Machining the first side
Parts are then screwed into the fixture and the second side is machined
Hullo would you share your files for these parts
Hullo again all parts for files cheers
Hi
If you are building this engine you should consider making a build log on this site
If you need help there are good people on here that can help you out
the plans are copyright
Some progress on the distributor, I have not machined the mounting point as yet, I will wait until the inlet manifold is made I'm thinking I might tighten it down with a clamp, not sure yet
Last edited:
Made a start on the heads
I think these are going to take a while there is a lot of work in them
I think these are going to take a while there is a lot of work in them
Base of the carby machined out ready to be finished off in the 4th axis
yes i am building this engine and i have a set of plans, I am talking about sharing the G code to make the parts that you have made cheers
