Center For 3in Rotary Table

[bmac2]

First post and I’ve made a total mess of it. I won’t work in the shop tired (saves on bandages), don’t know why I thought I could post something. I’ve got this in the wrong thread and I’ve made a mess of it to boot. My apologies. I’ll try again later. Maybe read the thread on “how to post a new thread” first
Even if that does sound like reading instructions.

 

[bmac2]

I think all things start with a 4 x 6 band saw

 

[bmac2]

I started with the fixed wedge. An angle of around 12 deg. gives me around .25” total vertical travel. Cut it down to about 1/2”at the small end and cut a 3/8 x 3/8 slot down the middle.

 

[Herbiev]

Looking great. Love the pics.

 

[rosenguyen]

Those things look great. Keep trying

 

[bmac2]

Those things look great. Keep trying

Hi rosenguyen
Thank you. This was my first post and I screwed up and put it in the wrong thread :fan:.
I did finish the center and if you like you can see the rest of the build here.
http://www.homemodelenginemachinist.com/showthread.php?t=21713

 

[PeperPan88]

Looking good, any update on this project mate?

 

[bmac2]

Hi Peper
Thanks for the interest. This post was a total cockup but I did do a post with the complete build. If you click on the link below it will take you there.
http://www.homemodelenginemachinist.com/showthread.php?t=21713