Search results

Try this when I was talked to doctor or nurse about moving around. I told with did the day before. That require a ½ hour or long why I should not work the AC electrical. Do not get on Ladder Do not get on roof Do not work electrical Do not work on 110°F day. Later did not about roof...

I think important to know not to use some words around Avation not because bad but taken the wrong way. I know on this site a lot uses FedEx and UPS for shipping and just do not think about the word you may use most time. ======================= Some things no one will say even print today...

FedEx has new pricing for lower cost shipping this year on small heavy boxes. I was down FedEx shipping. The want my driver's license. I start ask why I stop short . They keeping track just in case. I did not use the B work . We are talked the what B17 , B24 and B29 was built to care. Do not...

The varistor is surge protection is a lot electronics. It is a one shot protection like fuse. Can be real pain to replace. They are solder in to board. They are use whole house surge protection in some parts of USA. It will not protect electronics on same side as the varistor. It comes in...

Welcome to the group Dave

Welcome to the group Dave

Here is the technical data on the aluminum tape for anyone interested . Make Insulation easy. Dave

This only need on a wide range variable speed motors. The cost to save motor was under $14.00 and about 1/2 hour installing. No electrical just a good tape to motor. Most motor running on hight does not need any type of gauge. Seen more on mini lathes and mills variable speed motors. It...

This after the mini lathe ran for a ½ hour . It nice seeing temperature the motor is running not after I see smoke. Dave

I add a temperature gauge to my mini lathe. The mini use a variable speed motor. On low speed the motor does cool very well . So need watch temperature at low speed heavy cuts. The max motor is 105°C. Less the temperature to outside of witch is 15 to 20°C. I set red mark at 80°C just for a...

Welcome to the group Dave

Welcome to the group Dave

Over 200 letters for each size So 6 size x 200 letters is over 1,200 letters There is also starts , arrow, comma and list goes on. This is for all letters I have Dave

If came by my house I would give the letters and wax for free. The $30.00 is for going to FedEx and boxing. Dave

Yes I have lots foundry letters Full alphabet ⅛ to ¾" will give pattern wax too . $30.00 plus shipping. Dave

Welcome to the group Dave

When I had my foundry I would start fire in the curable. Let burn till curable was above 212°F . After start the furnace I would heat the ingots and tools in front furnace exhaust. Would buy leather coats fron Salvation Amry store . Used a face shield and safety glasses with welders gloves Dave

When a lot work a tapping head in drill press. I thinking of buying lead screw tapper fof both taps and dies. I found you could do about 6 tapped parts per minute or 360 parts per hour in drill press. A lead screw tapper is faster. FYI My parts had threads both ends. Dave

The Brown and Sharp book goes in detail for threading. The threading uses cams for threading and tapping. It also has thd rake angle for turn tools. This works great in engine lathes too. Dave

Welcome to the group Dave