Search results

HI nice shop

I wood love a mill but ther way over my buget

Hi a job well dun

hi if you send me a pm i can send you sum pics and files of the No 10 engine construction regards bob

well dun

Hi all right you no when you get a new mill cuter or a set of taps they sumtimes cum with a protective coting on them see pic 1 well you can by this stuff to put on your tools your self but theirs a nother way to protect them from damage and rust you will need sum petroleum jelly or grease and...

HI well thats brill

It may be too late but can i have one for xmas ;D ;D

HI well look for Harald hall Web page he did articles for model engineer on the billed of this engine their is templates of things you will find useful on the billed of the engine on his web page

HI ooooo that's nice i will av 2 of them right that's a bit big for me i have seen Moor and right ones that's the size that i won't to mack thanks for you help as per you work is brill regards bob

HI next question dus any one have plans to mack a tool makers cabnet

HI all right has Any one got pics or drawings of a mi ford lm7 Cross slide I need to no wot their is supposed to be on the end you have the acme thread then the end of the shaft goes threw the end bracket then their is the fix indext wheel then the handle shod the be fiber washers on the front...

HI all well I'm one of those that always makes up to much soldering flux and i end up putting the rest in old film canesters and freesing it it lasts logier but that's a pane as when i need it next i have to remember to remove it from the freezer the night before well her is the tip keep your...

hi i don't think its a steam engine not with them ports in the cylinders bin so far dawn

HI the type that i have has a flexible spout that i just bend up when finished so theoil runs back in to the oilcan

HI all right its all dun the last things to do was mack up a collar to fit over the tube then drilled and tap m3 this will-be the locking collar for the back Bering made up the knob for the locking pin this was made out of a old bush witch had the same internal diameter as the looking pin Holder...

so far so good don't have pics of drilling the dividing plate as the camera needed charging right i sharpend a cutting tool with a nice tip on it checked that it was cutting on center then i mounted the dividing plate then 8mm from the edge i scribed a line all the way round yousing the cutting...

HI all well I'm nearing the end I made up the mounting plate today this was a plate 2mm thick by 40mm wide by 140mm long divided the with then drilled two 6.2mm mounting holes 30mm and then 70mm from the bottom cut the angel for the tube to fit on to the angel was dun by dropping one side of the...

HI all did a bit more today the OD of the stainless steel was 80mm this wood be turned dawn to a OD of 75mm drilled the center 9.5mm then bored the center out to 3mm deep by 25mm diameter for the back Bering to fit in to then mashend the back of the disk to form a pocket see pic then marked out...

HI pete no