Jasonb's latest activity

I suppose it is a bit like the old traditional methods, yours is what might be expected from a good sand casting whereas Barrie's...

Gordon confirmed it was 102 Deg not 105 5 Thou is a lot of clearance for a small engine. You are unlikely to get the duration of valve...

Simply - because : where one cam operates the exhaust valve on both cylinders and the other cam operates the intake valve on both...

If you want to see it as two cylinders this is what is going on. Just two normal 4-cycles 360deg of crank or 180deg of cam rotation out...

I though this rang a bell I raised this issue weeks ago and said you looked to have about 50thou error due to deviating from the Upshur...

The simplified design will be fine with bound sand, most commercial foundries here tend to use one of the airsetting binders for just...

Thats considerably larger than what we are talking about here. That cylinder ends up 3.9" long Cores will be very small section and...

Suggest you read the drawings again, cams are not at 90deg on the drawings I have You also did not follow them regarding the mounting...

that is why I said they needed adjusting radially to suit bolt holes. It os equal side to side but spaced for either 3 or 4 holes But...

I only said it was likely to have been clad, without seeing the rest of the drawings and no signs of fixing hole son this one it could...

Going to be a fun one to sand the 3D prints smooth on and then work out how many tiny loose pieces will be needed. A lot of the detail...

That cylinder might be round but no way is it going to be an easy pull. It will need many loose pieces (retracts) as there are a lot of...

If you go down the casting route are you able to make the patterns and core boxes? If not then forget casting. If you decide to...

Have a word with ARC Eurotrade they do both the old and new belts for the X3. Not sure if they will ship to you though. You want the...

I'd end up throwing most of it away as a 1lts bottle of colemans lasts me a few years as I don't run my engines much once I know they...