mayhugh1

The on-board 'Autolite Voltage Regulator' module is a dc-dc converter that steps the 12 volt battery voltage down to a pot adjustable...

Returning with tail between legs ... A scope probe was capacitively coupled to the distributor's center lead to find out if the...

Gentlemen, Since I reported some of my health issues awhile back I thought that I should make a video of one of the two that I really...

A masterpiece from the true master builder and a fellow Ford enthusiast. I've learned so much from you over the years, and my latest...

Final video: the engine smokes a bit because I put oil in the petrol and the oil level is high, the engine is still running in

In preparation for the flywheel retro-fit, the bell housing was removed from the engine while it was still on the display stand. The...

Well thought out and beautifully executed. I need to start making my own plugs. - Terry

Spark Plugs are made using corian for the insulators, the corona is cut off a piece scrap I got from a kitchen manufacturer, it is the...

A Holley carburetor is an impressive assemblage of 'kludges' (only from a fuel injection perspective, of course) that supplies fuel to...

For me the most interesting part of a build can be the steps taken to get a newly finished engine running. Too often it's done behind...

Making a camshaft "blank". It's made of SS316 from a bolt - should be strong enough I guess.. Next up is to make bearing for it. Tons...

Hi! I'm trying to build a VW/Porsche engine in very small scale. The crank is ready. I found it challenging to make the cylinder's tiny...

No, just your typical 'thaw the water pipes' torch.

Sparky, The most popular use for a smoke machine is to find a leak an evap leak in a car. These leaks can be small pin hole leaks in the...

Sparky's diagnosis makes just too much sense. If it hadn't been for the strong suction at the carb air inlet even at wide open throttle...