stragenmitsuko
Well-Known Member
- Joined
- Jan 19, 2016
- Messages
- 326
- Reaction score
- 143
I'm thinking of making a few tangential holders .
Recently got a shoebox full of hss bits so I might just as well give it a go .
Much information is available on the net , so that's nota problem either .
All holders seem to use thesame angle for , what's it called , side and front clearance angle .
But searching the net gives me 7° or 12° and somtimes even 15° .
Same goes for the sharpening device . Two angles , always thesame in both directions
Angles seem to vary from 15° to even 45° .
So i'de like to ask people who have one or have made one , what angles do you use ?
I'm sure it's not all that critical , but if there's some concensus about this
Recently got a shoebox full of hss bits so I might just as well give it a go .
Much information is available on the net , so that's nota problem either .
All holders seem to use thesame angle for , what's it called , side and front clearance angle .
But searching the net gives me 7° or 12° and somtimes even 15° .
Same goes for the sharpening device . Two angles , always thesame in both directions
Angles seem to vary from 15° to even 45° .
So i'de like to ask people who have one or have made one , what angles do you use ?
I'm sure it's not all that critical , but if there's some concensus about this