Westbury Wallaby Likeness
- Thread starter D and D
- Start date
Help Support Home Model Engine Machinist Forum:
Great ! 
Awesome, show me more! show me more!
D and D
Active Member
Thanks, more to come. I hope to finish it over the Christmas break , I will keep you posted.
D and D
Active Member
D and D
Active Member
D and D
Active Member
D and D
Active Member
Running nice now, just need to finish the base and tidy it up.
Last edited:
D and D
Active Member
Finished
Engine is a 36cc parallel (360 Degree) twin based loosely on the Wallaby design by Edger Westbury.
Capacity: 2.2 Cubic Inch (36 cc)
Bore: 1.08”
Stroke 1.22”
Compression ratio 6 to 1
The engine was an experiment, I wanted to build something with the following:
Air Cooling
More than one cylinder
Closed oil system (Sump)
Pressure feed to the Big End Bearings
A High-Tension Distributor
Eccentric valve adjusters
Ground hardened camshaft with flat tappets.
Engine is a 36cc parallel (360 Degree) twin based loosely on the Wallaby design by Edger Westbury.
Capacity: 2.2 Cubic Inch (36 cc)
Bore: 1.08”
Stroke 1.22”
Compression ratio 6 to 1
The engine was an experiment, I wanted to build something with the following:
Air Cooling
More than one cylinder
Closed oil system (Sump)
Pressure feed to the Big End Bearings
A High-Tension Distributor
Eccentric valve adjusters
Ground hardened camshaft with flat tappets.
Last edited:
great !
congratulations, a nice and running well engine !
the engine responds pretty well to the carb setting, vrooom vroom
congratulations, a nice and running well engine !
the engine responds pretty well to the carb setting, vrooom vroom
Congratulations, Nice engine and runs great !
