hole debering

[krv3000]

HI all sum of you may all ready have this type of tool its one of things i made as a Prentice ? haw do you dee ber a hard to get at hole answer is with one of these bascley its 45 degre angel blade on a pivet pivet the blade to go thruw the hole dee ber the hole and remove the tool by repiveting the blad a ruff skech of the tool if i find the origenel droring for it i will post sos for my spelling bob

View attachment untitled.bmp

 

[GOOFY063]

Thanks for another tool project ;D i may never get to build a engine :big:

 

[kendo]

Hi Bob
Quite a neat little tool, i can see that coming in handy.
Thanks for sharing.

Ken

 

[Florian]

Those tools exist also as a commercial version, with carbide blade then...

BUT They have a small rod included that helps you put the blade in deburring position by pressing a button at the end of the handle.
After deburring you push the button again and the rod will move the blade for another 90 degrees so you can remove it without any problems...

Florian

 

[seagar]

Hi Bob, thanks for the idea,I will make one.

Ian (seagar)

 

[krv3000]

HI Florian I did not no that you can by them they have ovesley improved them by adding the rod thanks for the info regards from bob in the UK P's forgive my spelling ;D

 

[Florian]

Hey Bob

your spelling isn't relevant as long as i can understand what you mean..

Cheers Florian (from switzerland)

 

[kendo]

Florian,
I totally agree with you, Keep the posts coming Bob.

Ken

 

[krv3000]

HI all I have just looked in Quality tooling parts book and the listed in their but no price Email Address: [email protected] they have a lot of good stuff thanks all