Purchased this four stroke a couple of years ago. Trying to get it running, but it has no ignition system. I am experimenting with a set of MG points attached to the rear gear cover using the gear cover studs. Just going by old pictures found online. The threads are not metric as far as I can tell Something like 5/32" diameter X 36 threads per inch. Thats measuring OD of the thread. I have attached some pictures.
If anyone has drawings or information on this engine or the thread sized used in its construction, that would be most helpful. I think it may
have been a kit or home cast from magazine plans or something?
If anyone has drawings or information on this engine or the thread sized used in its construction, that would be most helpful. I think it may
have been a kit or home cast from magazine plans or something?
