Search results

I just quickly checked Its not hardened so it could be Iets see what charles thinks Chris

Yes thats right The radial arm is over 3mm thick Bud charles reckon its hardened Well i could test that with a file actually Chris

Hi jason 5.486 mm

Dont worry im not going over board Bud no rust and **** You know … Chris Look at the pins Brazed

Hi green twin I only take 1 thing appart make pics clean polish it and back toghther then next thing Apart ….. No mix ups Im very careful Chris

Hi charles Look at that

The problem is here Very stiff Am i take it appart and polish it?? Chris

I think the valve gear is the problem It needs to be taken appart Chris

Valve gear

Of course charles No responsibility bud i will do as suggested Its the experience witch i havent got If u got a final solution for the flywheel I will machine it If u think temporary is better i also do it Bud would prefer final Thank you Chris

Hi charles I start to your instruction The rods are just threaded in Not eaven a locking nut Clean up crank shaft and make flywheel What diameter and thickness u got in mind? I mark the pieces and make pics So i assemble it correct again Regards chris

Yes i do And if im on it i getting it as good as i can Possibly Also going for steam Started already. Got 2,5 mm thick copperpipe and…. Chris

The valve with is 29.512

See how crooked the edge is

Ok Hi charles The first part

Have to do it t morrow Chris

Ok done 8.775mm

I measure it anyway Thank you green twin

Hi green twin Is it that what charles mean?