Search results

Forgotten to attach that

Ok by the looks on this drawings We got basicly an outer ring with a lock screw on top which can accumulate the actual valvebody and both sliding in the rod Very very smart solution Awsome I take steel Or does it have to be cast iron? Less mess with steel Or valve cast iron and outer ring...

True I would apriciate that Chris

Hi charles Thank you very much for your work I didnt lap actually The movement is onyy sideways because of The depth of the groove So all i did was a couple of files on the topradius so it moves freely The slop sideways can only be eliminated by reducing thr round spacer in between The 2...

By the way did u see the video with the play of that slider? Chris

Hi jason I just thought before maybe top cast is not align with bottom I wait with that and see I clean the valve gear and make sure it moves freely and install back Chris

Yes I realy apriciate them green twin And also thank you I couldent do nothing without u guys Chris

Thats probably why the pins touching

Also got a lot of play Could reduce the disrance of the radial slider

Morning? Green twin It doesent thread in the center If i loosen bottom flanges ok If i tighten them Then its stiff because not center valve rod To gear

I slowly start understanding how It all meant to be One problem It binding up Eighter bend it or mill it straight on the bottom If i tighten bottom stiff

Hi charles The stroke is 50.2 mm with the verniere Chris

Sleep well

Thank you heeeeeeeps charles I checked the clearance on the brass block And the spacers between the radial arms They have to slide Are too tight bud Lap it?? Chris

Quick question Do the radius arms slide in the middle peace Where the rods getting screwed in?

Hi charles yes thats what i meant Bud it takes the strenght out of it I check whats left Chris

Yes

Well it wouldent be strong anymore Maybe not so good Chris

Thats the situation How about instead of shorten Cut wide part off thread and put wide screw In? Chris