Search results

Hi tornitore45 You seem to have found the perfect solution for my project, a V8 engine with a single hall sensor and distributor. I discovered that these Chinese CDI units will not trigger from a Hall sensor and now you have explained why, thanks for that. You say the problem is easy to solve...

Here we go again,look's like Manolis has invented the Wankel engine this time.

But make sure you use an aluminium bolt. If you use a steel bolt the anodising bath will be ruined

I have often thought about mounting a Dremel 225 flexible extension onto the side of my mill for light engraving work. The Dremel 200 series Multitool runs between 15,000 and 35,000 RPM and has a 125 Watt motor and a small collet chuck. This could avoid a great deal of work making a high speed...

Your illustration of the lobes, fully engaged, shows there is only a 0.1mm (0.004") separation between and surrounding the tip of the rotor lobes . Any backlash in the gears greater than 0.1mm (0.004") will cause metal to metal contact between the two lobes. It is essential to minimize and...

What are the clearances when the lobes are rotated by a further 30 degrees and full meshed? Mike

Dont mess about with thermite. Do the job properly and nuke it.

Use Permatex on a Packard Merlin and use Hylomar on a Rolls Royce Merlin. Simples Mike

Looks good. A fine piece of naval firepower