Search results

Here's the type of cutter I've been trying to make. I've made several but none the right shape.How Do I cut a R.100 (100 degree radius) on a lathe tool bit?

I have a cutter drawing, it's been almost impossible for me to make. That's why I am looking for a commercial made cutter. I've made several but it's still not right.

Sorry for the confusion. Still looking for help with a cutter ! Thanks again

I highlighted the number. On the drawing the arrow is pointing to the very tip of the tooth. I attached the page I'm working on.

The highlighted figures are the O.D (Outside diameter).

Hello all, Thanks for the help !! Here's some more dimensions that might help. Center of shaft to shaft for the 40T (Teeth cut .047") and 20T is .589" (Teeth cut .048") Center of shaft to shaft for the 27T (Teeth cut .068") and 15T is .550" (Teeth cut .065") These are fixed dimensions of...

That's a good for connecting gears but ... the ones I'm trying to make don't all mesh together. Just the 2 each in separate areas. I'm looking for the cutter size if I stated it wrong. Thanks again

I'm having an issue trying to figure out what involute cutter to buy to make some gears. What I'm trying to accomplish...one gear with 40 tooth with O.D. of .824", another 20 tooth with O.D. of .431", these mesh together. Then another set that mesh one with 15 tooth O.D. of .444" and the other...

Nice little flock of Jakes...save them for next year when they are adults...keep one for a pet until then...Rof}

Hi Rod- That's a better idea than milling it off. I will try that !! Thank you... Dave

Thank you Gail !! I will see if it will fit what I need. I had to edit...I keep forgetting about the download section...thank you for the reminder !! Thanx again, Dave

Hello all, I'm looking for carburetor plans I could use on my Hoglet Jr build. Do any of you have any that you would like to share with me ? Thank you for your time !! Dave

I also have a red HF...my only issue is the free pulley (non motor end) for the blade can't be adjusted (I think) and the blade Cerf runs on the pulley dulling it very fast on one side !! I was actually thinking of milling the wheel down about .030" to keep the teeth off the pulley. Anyone else...

Hi Ove, I'm no expert either. But this (web links) might help you understand where and why the cam and crank align. There is a lot more on line as well. Hope this helps you some ! I have no afilliation with any of the links. Dave http://www.animatedengines.com/otto.html...

Why wouldn't you use R8 collets...they go up higher in size and a lot more common (lots of manufactures and cheaper). My mini mill uses R8 collets. A Grizz G0709. Dave

Thanx Ove !! Well done...WELL DONE !!!!!

Hello Ove, Did you take any pictures while making the cam shaft ? Did you make it on the lathe or a milling machine ? I am going to make my jugs out of ali with cast iron sleeves like yours. Not sure about how to cut the cam yet !! Thanx again, Dave

I have a new Royal SB 5C collet holder if anyone has any interest ? I also have the the other 2 pieces...not sure what they fit !! ?? !! V 45

The Y and X axis are both 12"..The Y was cut down a little to fit. The 6 would have been too short. You can cut these with a dremel cut-off wheel in no time !! My X axis was a 24 and cut about an inch off that one.

Your Welcome !!! V 45