Sarah's latest activity

Thank you 😊

0.090" wide x 0.065" deep should do the job.

Hi Jason, the o-ring I was thinking of is BS1806 012, CS: 0.070, ID: 0.364, OD: 0.504 Thanks again 😁

With the cylinder finished I moved on to the piston, piston rod and the pivot pin. On the piston I made room for an o-ring, I have no...

Even with the drawings he still makes an appearance every now and then 😉

Hi Mark, I made the drawings whilst I was laid up for a while. When I have finished my model then I'll do some updates to the...

Hi Jason, I've ordeted the SCBCR 1010 E06-APT Lathe Turning Tool and the 0602 inserts. I only need to chip another two inserts to...

Over the weekend I have machined most of the cylinder, only making two little mistakes. The first was getting carried away facing off...

Hi Richard, I don't possess a faceplate, or a four jaw Chuck yet. But the 4 jaw Chuck is on my shopping list 😊

Thank you for your reply Jason. I will endeavor to mount my next flywheel on the inner edge as you have done in the photographs. My...

Do you have a face plate? It shouldn't be too hard to set up with a faceplate. Before the development of chucks, machining was...

A lot will depend on the flywheel and to some extent the chucks you have as to how it can be held. If possible I like to hold on the...

Thank you for your comments. Do you set the inner cast face to run true in a four jaw Chuck? I haven't got one, but it's on my...

Watching with interest as I have the same kit unstarted. You’re making a great start.

The Flywheel has been machined and polished. I had a problem finding a good centre, both sides of the stub axles were off true, as well...