mayhugh1's latest activity

Ross, I was hoping Ed would reply as he was the author, but he may not visit this forum any longer. I'll try my best to answer your...

It's my own design. - Terry

I have been concerned for some time that when I installed the prop and tried to start the engine that the prop would unscrew itself from...

Part # 65-BEARING OIL CUP x 6 completed Gaskets cut by laser x 9 completed (Spare cylinder gasket shown) Repainted frame completed...

I've never been a fan of mounting IC engines over wood boxes, but they're handy for hiding nuisances like big ignition coils. I...

Brilliant! I'm envious. - Terry

The block and heads are by far going to be the most challenging parts I've made yet. There's so many angles and setups. To make that...

Also, I got itchy to start making stuff again so I started on the machining. Intake manifold: Intake manifold lid: Lots of 3d...

It's time for an update! The CAD is basically done. I have the blower, cooling passages, flywheel, crank sensor, pulleys... I still...

Coolant from the water pump enters the block through a pair of passages in the front of the engine and feeds the water jackets...

Before installing the oil pan, a graduated beaker of water was used to measure the volume of the sump at two arbitrary fill heights...

I managed to get twice as many rings than needed from the first blank, and so work was stopped on the second lot. With nearly all the...

Sparky, The parts that don't get painted are left as is - no clear coat. I've found the surface tends to be more resistant to stains if...