You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
J
Thanks I joined the UK site and asked the question to Keith about the venturi. I will also post my drawing of the cylinder with the...
-
J
The angle as drawn is far steeper than you would get with a taper pin reamer. Easy to make or buy something like this but with a smaller...
-
J
Im planning out my project and I am not sure about the venturi. I am planning to make one of these and I see the various articles say...
-
Loading…
-
Loading…
