Jasonb's latest activity

Here latex (emulsion) paint is sprayed with airless sprayers which is a completely different approach.

Use the one at the bottom which is an external mix type and the only one that may handle the coarse "pigment" Mix wants to be like thin...

You should be able to work that out easy enough. The slicer software gave the print time for the group so just use the same settings and...

Must have been the file names that made it look like they were patterns 😄

Pat have you given any thought as to how you will fit and do up the conrod bolts? There is a reason the original engines had a hinged...

Had it been the correct flywheel for the engine then the long print time could have been recovered by printing missing features and...

You have also left yourself quite a bit of machining to do, if you had cast it with the raised narrow edge to the rim you would only...

Don't need my tape measure to remind you that you have not modeled the hub clamp even if it is going to be a dummy it is quite a...

It is not a conventional carb, more a valve to alter the air/fuel ratio. Most of the speed control comes from advance/retard of the...

You don't see many bases because most of the engines had the feet cast as part of the crankcase, only a few had the separate base. If...

I've only looked into the BambuLabs one but it is the same principle This guy explains quite well what the different colours and the...

I would also single point it on the lathe with it held to an angle plate on the faceplate. Or these days thread mill as I now have a CNC...

Yes, I'm using an RMC vapour tank and carb(mixer)

try this on the other half then the lower part can be done quickly with just the top at a smaller (slower) layer height where it gives...

Do you need to add some core prints to that pattern before putting it into the slicer? Is there no variable height setting as the...