Jasonb's latest activity

It works for me and I get the designs complete and the engines made. Your unusual method of using 2D drawing from one program and...

I would not rush out and get a faceplate, the 4-jaw will be much more useful. I just had a quick count up and I must have machined at...

On a model like that you are not going to be wanting to use much in the way of stock UNC and UNF fasteners so better to create your own...

Sounds more like a DP gear, measure it in inches and do the maths 14.5 pressure angle is also more common on DP gears so that also...

Before you do anything you need to think about the following Scale As I mentioned above with an engine this size you are likely to be...

I always design my models at the size they will be built. Although you can apply a scaling factor to a full size design you will then...