Gordon's latest activity

Yes. My poor typing skills strike again.

You have to send them a .STP or STL file. Quote comes in just a couple of minutes.

OK I will try to regrind it in the headstock and if that does not work I will just buy a new one. I should be able to cobble up...

I just had some gears laser cut from 1/8" brass and they came out very nice. The price was also very good at about $8 each for a 2" dia...

I have this ball bearing center which got too close the the tool bit. I would like to regrind the point but I cannot figure out how to...

Are you able to take food into the building or at least snacks? Are there vending machines?

But why do I have to learn so often?

Obviously I am not the only one who has a problem figuring out how the bits are sharpened. I have seen variations of the holder in right...

OK Thanks. That is what was confusing me. I know that it needs both side and rear rake so I was wondering if the rake was generated in...

I have been thinking about making some tangential tool holders for the lathe. I found this which shows one design. There are many other...

I have not been to either of those unless you mean Jeffries Antiques at Findlay. We have stopped there. I read my Kindle and my wife...

Yes. I saw the video but I have never been there so I am not familiar with the layout. I guess that I will have to go to see how it is...

So am I correct in assuming that the model engine show is set up in the same area as the cars in the aisles and not in a separate area?

Ok. I will take a look at the website. I will probably go. I live about 2 hours away so it is doable.

How big is this show? Does the ticket let you into all of the museum or just the Model Engine Show? I have not been able to find out...