You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
The last thing I found was reference points and reference lines. In drawing the cam for this engine the center of the shaft was Y=-.25"...
-
I have mostly figured it out but I am using Atom which has some very real limitations but I am not going to pay $400 for Design. Atom...
-
I think that you may be right. I have drawn the engine in Alibre hoping to see the rotation but that will not show rotation because it...
-
I have a subscription and I received an email to download it when it was released.
-
FYI. I did receive#39
-
I have built a Comber Rotary Engine and I am having a problem getting it to run. It seems to hang up when the cylinder is about 30° past...
-
Mike Rehmus publishes "Model Engine Builder" magazine. Subscribe and you will receive it when it comes out...