You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
Got some more work on the carby done
The hole for the barrel didn't come out absolutely round so I will run a rear through it and...
-
Basil reacted to
Bazzer's post in the thread
Metal 3D print with
Like.
We did not get any such problems on the NB 40 cases done by DMLS process. We are assured that the material is homogenous and consistent...
-
Basil reacted to
f2cf1g's post in the thread
Metal 3D print with
Like.
The accuracy of the selective laser melting (SLM) process is specified as plus and minus 0.3mm so I made the crankcase and cylinder...
-
I was going to fabricate this part from brass but then started thinking about maybe a 3D print in stainless steel offered by PCBWAY. I...
