littlelocos

I sent a PM with ordering info. Thanks, Todd.

I work long hours, but I do the work for myself and my company, so nobody is forcing me to do it. I often just outwork my competitors...

Michael. Thanks for the mention. Drawings and instructions for Pip are still available. It's hard to believe that the design turned...

There have been some updates with needed corrections to the drawings over the years. Please feel free to ask as needed. I've attached...

Wow! When I started this thread I had no idea of all the helpful, and varied comments, that would be posted. Thanks all, and keep them...

Hi Lloyd I hear ya...well actually I don't ;) my hearing is really bad. I started on the cheapo hearing aids from amazon about $50 and...

I've had mine for about 11 months and they've been life-changing. I have had nerve deafness my entire life with loss that varies with...

I was cleaning around my shop and have decided I won't be building this kit, so it's on the block. This is a kit by Dennis Howe of the...

Great suggestion. Thanks! I can see where the bearing could be pushed for sure. I use a prop-drive style adapter that doesn't rely on...

Hello @michael-au. Looking at the drawings and photo #24, the 0.312" shown in the instructions should be 0.031" as measured with a...

Saw this over in the live steam forum, she was 93. https://modelengineeringwebsite.com/Cherry_Hill.html

It is not so much the flame temperature that matters but the total heat output. So for fabrications a propane torch along the lines of...

Hi I am in complete agreement with Dan and Green Twin. Especially flux and cleaning. Planning your job is important, you need to...