bluejets

Exactly what I said. Hint would be, coils need to be wound in a given sequence to operate as a generator.

Think you need to take a good look at the way the coils are shown as being wound in #18 above.

You will NOT have sufficient space to fit that amount of nichrome wire. As I said, refer ohms law. My my what a load of weekend experts...

So kero not diesel fuel.

I doubt you will get sufficient resistance from a small heater coil to run at 6v let alone 12v. Reason why rc glow plugs run at around...

They're out of stock and no dimensions other than already quoted.

As far as I am aware it is standard nichrome wire. I have rolls of the stuff here left over from the days of repairing ice machines.

Have any video on that?

Which bushes specifically are you talking about? My manual from that same period has no numbering such as you refer to. The main spindle...

Main query would be, why do you think you need one ? Model diesel engines will not run on conventional diesel fuel anyhow. If methanol...

Small percentage of acetone (10%) works as a catalyst and negates the problem. I remember we would tune our 1/2a motors at home then...

Not difficult.....all the components (3) come assembled on a module (KY-003) Signal connection directly place where points normally go...

Hall effect can be utilised using the "missing material" method, no need for a magnet on the flywheel.

Hall effect and magnet cost would be less than an ice cream. 3144 and a 3x1.5mm magnet around AUD$3.00.